@article { author = {سلاجقه, علی and نیشابوری, علی اکبر صالحی and احمدی, حسن and مهدوی, محمد and قدسیان, مسعود}, title = {An Experimental Investigation of Three Dimentional Flow Pattern In River Bend}, journal = {Iranian Journal of Natural Resources (Not Publish)}, volume = {58}, number = {2}, pages = {-}, year = {2005}, publisher = {}, issn = {}, eissn = {}, doi = {}, abstract = {the process of flow in a river with regard to the river's characteristics such as the kind of bed, roughness coefficient, longitudinal slope as well as the governing conditions in the watershed (basin) is quite varied and complex. These variations along with complexities reach their highest values when flow occurs along a bend or river meander. A study of this phenomenon as it occurs in nature is very complicated , requiring sophisticated lequipment and instruments. In order to limit the variables and at the same time introduce a suitable pattern of a river bend (meander) that represents the effective principle dynamic parameters, a physical model, namely a flume of 180° curvature was constructed as a simulation. The bed and sides of the flume were constructed from plexig1ass, allowing a uniform flow to occur at a rate of 50 liters per second, at a width and depth of 60 and 20 cm respectively. Three dimentional (x,y,z) velocity measurements were made at different sections using a micropropeller . In total, nineteen cross sections of 10° intervals wer taken for evaluation. A maximum of 49 points of three dimentional velocity measurements were made at each cross section. Results indicate: a maximum of transverse gradient at water surface occurs at 90° curvature while a minimum occurring at 30 and 100 degrees of the bend. A study of in depth three dimentional velocity profiles indicates a maximum flow velocity at a depth of7.7 cm from bed surface and a minimum at a depth of 5.7 cm below water surface.}, keywords = {}, title_fa = {بررسی آزمایشگاهی الگوی سه بعدی جریان در قوس رودخانه}, abstract_fa = {رایند حرکت آب در رودخانه با توجه به ویژگی های رودخانه از نظر نوع بستر ، ضریب زبری ، شیب طولی و همچنین شرایط حاکم بر حوزه آبخیز آن کاملا متغییر و پیچیده است . این تغییرات و پیچیدگی در قوس و یا میاندر رودخانه به حداکثر خود می رسد. مطالعه این فرایند در طبیعت با توجه به وجود متغییرهای فراوان و شرایط غیر قابل کنترل امری بسیار دشوار است . لذا با در نظر گرفتن پارامترها اصلی و قابل اندازه گیری یک مدل فیزیکی در آزمایشگاه طراحی و ساخته شد . این مدل عبارت است از یک فلوم با درجه انحنای 180 و جنس مواد کف و کناره ها از پلکسی گلاس با جریان یکنواخت معادل 50 لیتر بر ثانیه و عمق 20 و عرض 60 سانتیمتر . مولفه های سرعت آب در سه بعدx, y, z در مقاطع مختلف با استفاده از دستگاه میکرومولینه اندازه گیری شده است . در مجموع 9 سطح مقطع عرضی با فواصل 10 درجه و در هر سطح مقطع عرضی در حداکثر 49 نقطه و در هر نقطه مولفه های سرعت در سه بعد اندازه گیری شد . نتایج نشان می دهد که تغییرات عمقی سرعت طوری است که حداکثر شیب عرضی سطح آب در زاویه 180 درجه قوس و حداقل آن در زاویه 30و100 درجه قوس است بررسی پروفیل های عمقی سرعت در هر سه بعد نشان می دهد که حداگثر سرعت آب در عمق 7/7 سانتی متر از کف و حداقل آن عمق 7/5 سانتی متر از سطح آب است.}, keywords_fa = {}, url = {https://ijnr.ut.ac.ir/article_25490.html}, eprint = {https://ijnr.ut.ac.ir/article_25490_f80519da89a72647a75d8e1bee30132c.pdf} }